M_C rebuilds his grow room

[reganlives]

Good luck mate! Hope it goes well

[M_C]

You seen this stuff dude?



If you lined it with ply then stapled this to it it'd reflect the heat back into the groom. Plasterboars isn't that good of an inulator on its own.

My old tent was in the cupboard before & I was fine with temps bar mid summer (when everyone suffers) so I'm not overly fussed about thermal insulation. I did consider using thermal board on the outside wall though...

[Dirty_badger]

Ahh fair enoufh dude. Just my 10p worth lol

[M_C]

Ahh fair enoufh dude. Just my 10p worth lol

No problem, it's good advice

[ReD RuM]

That's a cushty little space possibilities are endless!

[MrG]

Oooh mini tree machine on the cards
Could fit a nice little system in that space.
Good luck mate:thumbup:

[M_C]

Ah! Mr Thor... just the person... I was thinking about dropping a 2 gang consumer unit in.... but the ones I see come with 40A 30mA RCD & 2 x MCBs (1 x 6A
1 x 32A) - I assume that's just far too large for the job?

One side would be fans & associated ventilation (no more than about 100/150w max) and the other for the lighting (allow for, say, 600w & any surge for HPS)

what would be good swap outs for the RCD & MCBs?

[MrG]

Ah! Mr Thor... just the person... I was thinking about dropping a 2 gang consumer unit in.... but the ones I see come with 40A 30mA RCD & 2 x MCBs (1 x 6A
1 x 32A) - I assume that's just far too large for the job?

One side would be fans & associated ventilation (no more than about 100/150w max) and the other for the lighting (allow for, say, 600w & any surge for HPS)

what would be good swap outs for the RCD & MCBs?

Couple of 16A jobbies should do you mate

[M_C]

Couple of 16A jobbies should do you mate

Thanks Appreciated mate

[satnavsatnav]

It's about time M_C :-) can't wait to see ya growing bud