Ok so changing my groom about and I've got several types of bulbs etc
Setting up 4 stages in the room for easier use, still staying well within the personal limit of growing but just making it much easier to have different stages of the plants since I'm using autos and lights are always on 18/6
I've got a 250-600w ballast for seedlings and baby plants in its own section of the groom which I'm using a MH bulb and the wattage down at 250w as not to cause too much heat stress.
Then I've got a 600w ballast with a MH bulb again for the first few weeks of the plants life
Then it goes to a 1000w ballast and a HPS bulb for the rest of its lift cycle before moving to the last light for flushing the plant, the last light is a 600w ballast again but what's best to use for flushing? Metal halide or HPS?
I've got 2-3 plants under each light at the most so plenty of space, with it being autos it's always a small yield from each but the bonus of quick turn around gives me a few ounce of a different strain every 4-5 weeks so think this is finally the best setup
It's a autopot setup with a tank of plain water, I just hand water the nutes when needed, and then then on the light at the last stage when flushing out when needed
Always handy when you have extra equipment lying about, saves switching lights etc at certain stages. I just lift the pots from one section to another, they always have water due to the main tank
Opinions? On lights etc?
Sent from my iPhone using Tapatalk
Bookmarks