Help! Amazon aero issues

**Dittogrow** · 10-10-17, 09:17 PM

it's low pressure sprinkle.
i noted most of the roots were submerged in water as the drainage was filled with roots so what I did was to angle it a bit so water leaves top faster and goes back to reservoir. Still not much of a help

**Dittogrow** · 10-10-17, 09:20 PM

could that be once you screw up oncee you can never go back to healthy plants in aero and I have to start again ? New leaves are curling too.

**Memphis69** · 10-10-17, 09:23 PM

Found these symptoms wonder if any of these could be of help??

Sent from my iPhone using Tapatalk

**Dittogrow** · 10-10-17, 09:59 PM

after inspection plants are not shiny so maybe not the mites. wind is the suspect for now, but it's all leaves curling and all the plants.
No ideas , except for the water temp

Hobbit · 10-10-17, 10:06 PM

Originally Posted by Memphis69

Is it a true aero system? (High pressure mist) or is it a low pressure pump sprinkle??

Sent from my iPhone using Tapatalk

Why would this matter?

Originally Posted by Dittogrow

could that be once you screw up oncee you can never go back to healthy plants in aero and I have to start again ? New leaves are curling too.

IMO you can correct things very fast in aero.

Originally Posted by Dittogrow

after inspection plants are not shiny so maybe not the mites. wind is the suspect for now, but it's all leaves curling and all the plants.
No ideas , except for the water temp

Mate from how you describe the shiny leaves its sounds overfed. Sure your meter is working. Try get some proper pics mate without that HPS yellow. Lots here wont answer anything with those pics.

**M_C** · 10-10-17, 10:13 PM

Originally Posted by Dittogrow

current water temp is 24.5C , reducing it now with ice.
what scales you want?
mS/cm 0.72
510 ppm

Hydro ain't really my forte... but, the numbers that would help are the mS/cm of the water before you add the nutes (I assume the 0.72 is once nutes are added?)

**Dittogrow** · 10-10-17, 10:21 PM

Originally Posted by M_C

Hydro ain't really my forte... but, the numbers that would help are the mS/cm of the water before you add the nutes (I assume the 0.72 is once nutes are added?)

0.09 mS/cm, 69 ppm. without the nutes
I will get you guys photos soon with cfl lamp

**Dittogrow** · 10-10-17, 10:48 PM

Hobbit · 10-10-17, 11:14 PM

The purple petioles and the rusty looking spots look like cal/mag deficiency.
I had a similar problem with droopy leaves and all, I t my problem down to too much N locking out the cal and mag. Your plant doesnt look dark enough to be over fed on the N.