Having temp issues,

[bubbles93]

Hey so running 4 plant on 600w with 2 inline fans but the temp can exceed 30-32 at max and i'm worried because i plan to flip them in a few weeks, i'm a complete noob to growing and i think my air circulation setup something is wrong but i would like some advice on how i can get these temps down, because the bulb hood can deffo get very hot, https://imgur.com/a/P99GC, i got filter>lights>extrator>then ducting out to window, and i missing something here because my room temp is very cold but my tent temp is waay to high than i need it to be

[joker_the_smoker]

what size tent you in? what size extractor you running? what reflector are you using?

shudnt be struggling with a 600w in this weather tbh

[xx420xx]

i know this is a daft question but are you sure you got the fan running the right way, i.e sucking air out of the tent? also have you got ventilation into the tent. The air been sucked out has to be replaced with cooler air right?

[bubbles93]

ohh i see, yea the extraction fan were running the right way yeah, but i hadn't had any ventilation into the tent, how is the best way to go about venting air in?

[bubbles93]

and no questions too daft for me pal you'd be suprised haha

[Ironman]

and no questions too daft for me pal you'd be suprised haha

Just open the vent flaps on the side of the tent. Usually velcro😉

Sent from, Thames Iron Works.

[bubbles93]

im actually crying out how daft i must be looking rn hahahahaha, thanks boys top notch support as always

[joker_the_smoker]

looking at that pic your ducting is a mess aswel, what about running separate ducting for the cool hood and separate ducting for filter as thats how cools hoods are supposed to be used

[Ironman]

looking at that pic your ducting is a mess aswel, what about running separate ducting for the cool hood and separate ducting for filter as thats how cools hoods are supposed to be used

Well spotted jokes😁 I agree.😉

Sent from, Thames Iron Works.

[Ironman]

You could just spin the hood round. Then you only have 1 bend either side of the hood not 2. You will have to move the filter from the left hand side to the right hand side.

You can also lower the filter so it's between the lights and the plants. It's much more efficient when you trying to lower temps.

Sent from, Thames Iron Works.