Hi having problems with water ec

[420Rancher]

U say. 8 is good for young plant so some time. 8 is plain tap water is that wot u are saying?


Sent from my ANE-LX1 using Tapatalk

You said after adding half nutes, so you know they have what is needed to grow, let them grow watch the plants, never trust a meter, only use it at a guide,
Kbag has a valid point about calibration! But my well water does see these fluctuations based on water usage in my home and environmental conditions.

Define young plants
1-2 weeks
4-6 weeks.
I keep my ec low when the plants are small and establishing a root system, then once the roots are established, you will see a major change in the plants growth rate, at this time i bump the numbers up as the plant will require the nutrition thru the spurt, to low and you just get slower growth.
Too many people are tempted to overfeed the plant trying to get this growth spurt, but you must wait patiently for it and react when it comes.
Are you doing photos or autos


Sent from my iPad using Tapatalk

[Potkettle]

PH is normally.around 7
And use auto pots coco and clay pebbles

Sent from my ANE-LX1 using Tapatalk

[420Rancher]

Do you have a diary with any pictures?


Sent from my iPad using Tapatalk

[Potkettle]

No I don't I'm afraid
I did over dose last grow and ended up flushing the in Bath cos ec runoff was around 1.7 and stunted one of the plants and all turned yellow two soon

Sent from my ANE-LX1 using Tapatalk

[420Rancher]

I have no experience in coco, but to me 7 sounds high.
In Rdwc during veg i try to be about 5.8-6.3 lower in flower.

I know that coco has some unique tendencies, with ph but forget what they are.


Sent from my iPad using Tapatalk

[Potkettle]

Sorry my tap water pH is 7
But I nock it down to around 6

Sent from my ANE-LX1 using Tapatalk

[Potkettle]

I believe coco is ec and pH neutral

Sent from my ANE-LX1 using Tapatalk