Ok my friends wanted me to do a small 7 g run for them. The strain was double dream.
I decided I wanted to document this little run for fun on here to show you guys how to make bho.
We first start by packing the extraction tube, you can find these at most head shops. Different sizes for different weights of bud. You want it packed tight but still have air flow. For nug run you want your nugs in little popcorn nugs. After it is packed you want to put a silk screen or coffee filters (bleached preferred) and a clamp or electric tape to hold it on the end as a lid.
Ok then you pop the Tane (butane) and the tube in the freezer and wait. How long you keep it there can vary, I like keeping it in the freezer over night, but in this case I only did 30 min cus is such a small run, 448 gs compared to 7 gs is a lot lol.
I'm gonna make a side note. Your choice of tane can vary. As long as it's 5x refined it's good. In this run I used vector.
Ok so after it's in the freezer you take the tube, tane and a Pyrex bowl or dish OUTSIDE. Caution I specify outside because we are dealing with highly flammable gasses, and without the right ventilation and proper care, YOU WILL EXPLODE, but enough of that just don't blast inside or light a cig or joint while blasting, those are big no nos.
ok sorry for me getting side tracked, important things you must take note of. You then put the spout of the Tane can into the extraction tube push down and let the butane run through the weed out the coffee filter into the Pyrex.
Ok so after this what you will have in the Pyrex is highly flammable, you will need to heat it up to get the butane to evaporate off, but you can't get it too hot to burn the THC, there is many different ways to do this in this process I put it on a heating element at 95 degrees Fahrenheit.
After awhile it will start to bubble up and basically harden and form an oil like substance
You then will want to scrape all the oil from the Pyrex on to a piece of parchment paper.
You are not ready to smoke yet though. There is still a lot of butane in this solution, you need to purge it. You will put it into a metal chamber on top of a griddle warming it up to 95 degrees Fahrenheit
Once it's at 95 degrees you will pressurize it to 30+ hg using a vacuum pump, at least 3 cfm
The oil then will muffin up, the effects of the butane leaving the substance, and you will leave it there for 24 hours
After that 24 hours you will do the flip and put it in for another 24 hours, I will be updating the post once I do the flip tomorrow. And keep updating this post until this little slab is done.
Check out my auto flowering stealth grow, I will be updating that in the next couple days with germinating pics and planting and what not
Stay heady 🔥🍯👌
Bookmarks