Hey dudes, im finished buildin my waterfall rdwc system, and am thinkin about incorporatin a venturi into it.
I was lookin at 22mm pipe with a tee facin upwards. Inside the tee i was plannin puttin a bit of 19mm hose, with some slots cut in nthe bottom.
Now the idea is that this slotted hose would slide down the up pipe of the tee, till you reached the sweet spot, where it would introduce air into the passin water in a venturi effect,
obviously you would have to raise and lower it until it started to take the air on board, but im sure it would.
This would hopefully increase the DO in the totes no?
Has anyone tried this, and do you think it would work. or am i pissin into the wind?
I am usin a 3000 litre per hour pump
Any input?
thanks
Bookmarks