OK so I've had to start a new cubaord all ready as I figured out the one I built isn't big enough to hold a couple of mothers and my heated propigator.
Plus as I'm growing five strains at mo and there all finishing up at different times ????
So for now it's going to be a drying room then a Pepsi challenge cupabord and finally mother room.
The size is 1.8mtrs tall 700mm wide and 500mm deep
When I baught this it was really flimsy so I had to weld three of the front corners to stiffen it up.
For now I've managed to install sockets and fan and filter
This all ready simple build has taken way longer than it should due to a few issues.
One being the fan I ordered can smashed so I've had to gaffer tap it back togeather u till I find an alternative.
The filter I ordered I thought the 300 was the length but no its the flow rate so is way longer than I wanted. Which isn't really a bad thi g as it should last a lot longer. Its a can o lite filter
Once all is done I will paint the outside as its not very pretty ut for the moment it's functional.
Bookmarks