First go at cloning. First go at cloning.

[MrC]

So then, I accidentally set myself on a journey. See here https://www.thctalk.com/cannabis-for...dam-and-Eve-it

I've setup this tub as a propagator, got an average humidity of 64% inside the box, heat about 23-24c. Stuck a hose on the end of the humidifier and fed it into the box through the bench and lid. It's on 75% + today though. Also got a pc fan at one end on 3v and a few holes on the opposite side, get some fresh air through, doesn't seem to affect heat/hum.

Not much else to say atm, followed Bud's guide best I could regards taking clones, was pretty simple but so am I Any criticism welcome. Main things on my mind atm are how wet should the root cubes be, right now they're just moist, not saturated. Is the best way to keep em wet to just drip water on em? Also how often am I looking to spray the clones with water? As I'll be doin it by hand.

Some phiotios

Mama



Setup






Dunno what the feck I was thinkin when I made that tin foil contraption already replaced it

Strain is Blue dream by Humboldt, little led light above it...lets make some babies

[IceCalibur]

Love it, well done MrCanna, cracking job, good bit of diy that..should work perfectly!

With the root riots, I used to stick them in some water, let them soak up what they can, then squeeze out the access bud, that way they're not dripping/soaking, but no dry spots.

When/if they start drying out, just water them as you normally would, doesn't need much and making sure they're not sitting in any puddles after

[MrC]

Love it, well done MrCanna, cracking job, good bit of diy that..should work perfectly!

With the root riots, I used to stick them in some water, let them soak up what they can, then squeeze out the access bud, that way they're not dripping/soaking, but no dry spots.

When/if they start drying out, just water them as you normally would, doesn't need much and making sure they're not sitting in any puddles after

Thanks man, one of the few occasions the build fell just right, even had a hole in the table for the hose, pre drilled to clamp the rosin press lol. I'll be keepin a close eye on em. Be lookin to flower the mother end of september so plenty of time to try with the clones. Should get a nice pile of christmas bud off that main plant.

[WhIpLaSh]

Love a build, nice job, MrC! Let's see them rootsssssss!

[Dirty_badger]

What's the 25L bowser do on the left?

Sent from my SM-G975F using Tapatalk

[MrC]

Love a build, nice job, MrC! Let's see them rootsssssss!

Here's hopin, it's a beauty of a strain, smoked a lot of it

What's the 25L bowser do on the left?

Sent from my SM-G975F using Tapatalk

I got 2 of em to fill up and keep downstairs as I was using at least 18-20 ltrs each feed/watering, so just cuz I'm lazy and can't be arsed to keep walking up and down the stairs with buckets really

[Dirty_badger]

Fair play dude. I'd deffo bang a push fit supply in straight through the ceiling

Sent from my SM-G975F using Tapatalk

[MrC]

Fair play dude. I'd deffo bang a push fit supply in straight through the ceiling

Sent from my SM-G975F using Tapatalk

Just had a quick look at that, I'll de;ve deeper later. What would ya do, hook it up under the kitchen sink and feed it down?

[Dirty_badger]

Your kitchen upstairs?

Sent from my SM-G975F using Tapatalk

[MrC]

Your kitchen upstairs?

Sent from my SM-G975F using Tapatalk

Yeh man, it's garage and utility/grow room on ground floor, kitchen and lounge on 1st then bedrooms and bath on 2nd. Tbf the washing machine is in utility room so could maybe hook something up to that to fill barrels up?