PART ONE
Ok chaps following the "Gumbo" method i made some hash using the trim from my LSD harvest, if you could call it that lol
Heres what ya need.....
Tea
Spliff
cling film + bowl
Drill with wooden spoon
Ice
Buckets
Sieve
coffee jar
and of course some trim
id advise putting a towel down before you start.
Ok so i fill the mixing bucket halfway with cold water - filling halfway came in handy later, by pure accident i might add as a lack of more than 2 buckets meant i could do a second run.
Then i add my ice and trim to the mix
Now the messy bit! i mixed for 30/40 mins using my wooden spoon drill thing.
Now i get my other bucket ready for the mix to be poured through the seive. this is my 1st run!
After i poured through the seive i then added more ice and more cold water (i could because id only filled the bucket halfway for the 1st run) and mixed that again for another 30mins. This was the second run!
And after pouring the 2nd run through the seive heres what i was left with.
So i then lifted the final resin bucket above the mixing bucket and left it to settle for 5hrs. after waiting for the resin to settle i then used some tubing to syphon out the excess water (being carefull not to go too close to the resin thats gathered at the bottom - try and leave an inch of water if you can)
After syphoning off as much water as i could
Bookmarks