How to make colloidal silver

[FACE]

How do U no that it's the correct ppm ?
U need around 40-50 ppm silver for it to work 50 being better
Nice easy way of doing it mc quick n simple be interesting to see if it works this way

[Hedonistic Hippy]

Why store it when it is so simple to make?

Just curious mate...obviously won't use a full bottle... So whatever's left just wanted to know if it would keep is all...but yeah..good point.....

[Shamoo]

the way I seen it done was 3 each 9 volts in series ,distilled heated water , in total darkness (black vessel or black room must be glass vessal) the power is applied to the hot water takes over night & particle size is correct the arranging of wire & what you did in assy is the same you can use silver bars as well more surface area thingy
I have my parts just need to put together & i'll report back
disclaimer : I know this works well but have not done it myself ,but have seen it done
OK not tryin to hijack sorry in advaance

[Hedonistic Hippy]

How do U no that it's the correct ppm ?
U need around 40-50 ppm silver for it to work 50 being better
Nice easy way of doing it mc quick n simple be interesting to see if it works this way

If concerned about ppm can you not use a ppm/ec meter to measure c.silver?

[Shamoo]

the process I refer to the heated water & distilled keeps the partical size small
pure silver is way better as you get a pure product & not them fuzzy things on yer silver electrodes
most jwerelry silver is 98 % - 95 % silver those allys are not great in yer product
will keep in refer in dark bottle quite a while .
there is many different ways to do this but start with pure silver & not introduce other heavy metals into yer grow

claimer don't smoke the treated area a heavy metal was applied there
silver is not as toxic as other heavy metals hence Jewlery duH

[Shamoo]

If concerned about ppm can you not use a ppm/ec meter to measure c.silver?

yes ...

[M_C]

How do U no that it's the correct ppm ?
U need around 40-50 ppm silver for it to work 50 being better
Nice easy way of doing it mc quick n simple be interesting to see if it works this way

I had the same problem getting my head round the ppm business...

Ppm only measures the amount of silver in suspension but not the particle size... the only way that can be measured is in a lab

If the particles are too large then they will not enter the plant - regardless of ppm

So our real aim is particle size, hence the low voltage. You can use a laser pointer to see when things are done as the beam will actually show in the solution so you know sufficent silver is present.

Ideally a lower voltage is better but I tried this before (a few members did it at the same time) & got the result required

[Shamoo]

more than one way to skin that cat
high water temp & higher voltage was to insure particle size IIRC

I can't link due to rulz
but n my last post here , I'm not a thread crapper

[ganjagunman]

mobile phone chargers are around 3.5/6v as i said before, maybe that would be good

[Shamoo]

mobile phone chargers are around 3.5/6v as i said before, maybe that would be good

most have limiter that would see a c/s rig as a ground fault & switch off the power